I am having problems connecting to the network via my linksys usb router. When I installed my router there was no signal and thus it told me to make a new network when there is already a existing router. Thus only the green power led is on whereas the link led is off. Is there a way to extend the length of the signal from my router to my existing network? I know this is possible because the geeksquad set it up and when i did a destructive reboot (due to a system error) i couldn't connect to the network. Any suggestions?
Network difficulties (linksys WUS854G version 4)?
Have you attempted pressing the little reset button in the back of the router for 30 seconds, updating the latest firmware from www.linksys.com and reconfiguring the router as if you just got it? That may actually do it.
Reply:Ya need to call GEEKSQUAD and get them back there. You dont seem like you know what your doing (no offence) and if you try to upgrade the firmware or start making setting changes, its VERY possible you will make things worse. Linksys routers are VERY forgiving as long as you know what your doing. If I were you, I'd get GEEKSQUAD back there to fix it.
Reply:access your wireless router %26gt;%26gt; wireless settings %26gt;%26gt; adjust the channel and power setting
also please check for possible interference
ex. no base of cordless phone, loudspeakers (any electronic device) near the router and wireless adapter
dental bridge
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment